12 V 125-300 Ahリン酸鉄リチウム電池深サイクル

【1】

ハイエース旅で使う、ポタ電充電やエンジンオフでのエコフローwave稼働用で購入。早速、満充電して24時間後にアプリで状態確認。電圧低下や容量減も無く満充電時のままでした。そこから、定格600wのセラミックヒーターを稼働させて、実用量を計測中。1時間半程経過して、電圧も正常、容量の変化も適正。素晴らしい！の一言です。後は、耐久性ですね。

【2】

Bluetooth内蔵アプリでバッテリーの状態が見えるので安心して使えるBMSの保護機能も充実していて安心

【3】

まだ取付工事途中ですがBTでバッテリーの状態が確認出来るのが良い

【4】

Bluetoothでバッテリーの状態が確認できるので、とても使いやすい。

【5】

アプリでバッテリーの状況を把握出来るのは良いが、接続毎にQRコードの読み込みが必要とはお粗末。充電するにも電源ボタンをONにしなければならない。不便すぎ。常時、電源OFFで微放電。250Ahの容量に対して最大出力100AhBMSとかなり貧弱。電子レンジ等は使えないかも。かなり中途半端な仕上がりでガッツリサブバッテリーシステムを構築される方は購入対象から外された方がよろしいかと。

【6】

やっと設置と接続が終わり、使い始めました。コタツなどの電気を賄う予定です。これから様子を見ていきますが、出だしは良好で満足です。今後もよろしくお願いします。

【7】

2018年の大阪北部の大きな地震を経験していて、今年の能登の地震のこともあったので防災用に購入ひとまずスマホへの充電確認できましたこれから定期的に使えるかの確認しようと思います

【8】

以前作成したポータブルバッテリーの容量が80Ahだったのでコノ125Ahで作成してみました。ソフトで状態が見れるのとサイズが100Aｈと同じ大きさで良いと思います。あとは耐久性、使ってみます。ソフトでオンオフできたり、調整できるとさらに良いのですけどね。

【9】

We are using this lightweight battery in our gate opener. It is very light and easy to handle. Many things that are already terminated, like our gate, will have a .205 terminal on them. To fit these batteries, they will need to be replaced with a .250 terminal. Our gate opener holds two of these, which we installed after changing the terminals. This battery is working perfectly for our needs now.

【10】

- I ordered this as a general purpose 12V battery for testing, electronics, portable-use, etc. …as my lead acid ones have reached end of life.- This battery is considerably lighter than the lead acid ones, by an approximated 40-50%.- Out of the box, my multi-meter measured 13.2 V, so it comes charged, but you might want to top it off before use.- I don’t have a battery charger or tester with a LiFePO4 profile, but my lead acid battery charger/tester measured the CCA of this battery at 52 CCA. This is not designed or intended as a starter battery, but I thought I’d check anyway. 50A seems like a very healthy discharge rate for general electronics. Especially given that the spec sheet says 100W/8.3A.Bottom Line:Good battery, works, and seems to have a healthy discharge rate for a non-starter battery.

【11】

This LiFePO4 battery pack has all the important safety features that make it suitable for use: BMS current limiter, low and high temperature cutoff, and low voltage cutoff. The pack itself seems to be high quality and well made. I used a lower capacity version of this to replace a UPS battery. The original was a lead acid battery.LiFePO4 batteries are much lighter than lead acid batteries, and have significant improvements over LiPO batteries. They are slightly lower energy density (~10%), but they have significantly more cycling ability (500-1000 vs. 2500-5000), and they don’t require babysitting to keep their charge levels at a healthy level.

【12】

Please note this review is not for the 100 amp hour battery other than that the battery I got does exactly what it was meant to do and is fairly well made

【13】

I got this 8Ah LiFePO4 battery because I use them for a variety of portable things: fishing lights, fish finders, camp lights, charging cell phones, powering CPAPs, etc. My first impression on opening this battery was that it seems denser than it should be. At first, I wondered if I got shipped a SLA (lead acid) battery by mistake, but not so – that would have weighed 5-6lb while this battery is just barely under 2lbs. Next I compared the size of this 8Ah battery to one of my 7Ah batteries and it measured almost exactly the same - had, so it IS denser [heavier weight is the same volume] but has greater capacity.The ‘box’ it shipped in is very thin, paper-board, not even corrugated cardboard. This is fine but it does not provide any margin of safety if the box takes a hit.