ENGINEER エンジニア ネジザウルス

【1】

買って良かったです

【2】

でかくて良い

【3】

良かった

【4】

ボタンを押すのにかなり力が必要です。

【5】

掴んでいるとロックが外れて掴んでいられない。掴み物の風上にも置けないゴミ😞金返せ❗

【6】

幅が調整できるので、ネジがつかめないと言うことが格段に減りました。グリップ部分も他の製品より大きくて力が入れやすいです。

【7】

錆びて頭の取れたネジも抜くことができました。形状が狭いところや、障害物がある場所でも使用できると思いました。

【8】

少し使ったら大きさ調整のヒンジが壊れてしまい、使い物にならなかった。

【9】

I needed a good pump plier for my toolbox and this one does the job. I already have the screw extractor plier from Engineer and wanted the basic pump plier. There is a solid rivet holding them together you can't see very well in the picture. There is very little play in the jaws with that kind of secure rivet style. Build quality and finish are very nice.

【10】

メディアを読み込めませんでした。the adjustment pin walks off from its cavity and consequently open the jaws.

【11】

Che dire ,promette quello che dice.Qualità giapponese, dopo di questa non esiste altra simile... nemmeno knipex cobra che già posseggo 👍

【12】

Very nice and good quality

【13】

I'll save your time and skip the (few) things about these that might be good. I wanted to like these because I carry 10" 'channellocks' everyday, and these have the screw extraction feature AND tighter adjustment graduations. However, the geometry of the adjustment teeth( the grooves) is not biased enough (or, at all) to keep them from slipping to the next largest openings. I like engineer pliers in general, but these are trash, and could seriously get someone hurt. I'd love to see a reiteration of these pliers-with locking geometry that works similar to other manufacturers; because the special thing about these is the grind in the jaws, nothing else- but I recommend everyone shy away from these.